Multiple Drive System Adjustments Made Simple
 | Press Release: |  |
| Mar 3, 2006 — AutoDrill offers a fast and low cost method to adjust single or multiple devices with twist-type controls. Affordable devices can make the tedious or critical application simple. An operation that was once a complex problem is now possible, but can even become much more efficient. The devices are available with single input / single output, single input / multiple output, multiple input / multiple output configurations. They can be manufactured for a number of common and custom drive and control platforms. Input and output locations can be customized and are only limited by your imagination. AutoDrill customers have used this equipment to adjust multiple regulators at the same time to keep complex systems in balance. They have often been used in situations where human interaction with the atmosphere would be hazardous to employee health or safety. Others even use these devices to twist wire, hose or other products in a balanced, automated fashion. Such products often have a superior finish because there are no fluctuations during the manufacturing process. Because the devices can be manufactured with 1:1 or custom input:output ratios, they can be used to handle precise tasks. The output drivers can even be configured to run at different ratios from one another up to 4000 RPM. Multiple drive systems are sometimes so complex that they are completely unmanageable. This no longer needs to be an issue with the use of these products. Besides the multiple increase in production, there are additional benefits. Setup and operation errors are virtually eliminated. Tolerances are no longer a problem because the devices are geared to perform the same way each and every time. On-the-job injury rates are lowered and reported incidents of repetitive motion injuries are drastically reduced. The gear driven devices are constructed with efficient gearing for high spindle speed ratings and less noise. Full ball and needle bearing construction is used throughout. Industry standard ER collet chucks are built as part of the spindles, but custom interfaces can be provided for just about any need. One-shot grease lubrication is designed into every device for trouble free operation. For more information or additional photos, please contact: AutoDrill 50 Division Avenue Millington, NJ 07946 Ph: 800-871-5022 Fax: 908-542-0242 Website: www.autodrill.com E-mail: sales@autodrill.com | ||
| Categorized Under: Drilling Equipment |
 |  |
| Company Details: | |
| Contact: | Joe Agro | ||
| E-mail: | |||
| Company: | Autodrill Co. View Company Profile | ||
| Address: | work50 Division Avenue | ||
| Location: | workMillington, NJ 07946 United States | ||
| Phone: | workpref800-871-5022 | ||
| Fax: | fax908-542-0242 | ||
| Web Site: | http://www.autodrill.com | ||
| |
